4
INSTALLATION Unpack the KELTIK AKTIV and retain the packing for future transportation.
CAUTION Take extreme care when handling the Keltik speakers – they each weigh 51KG.
Your Linn Dealer is responsible for ensuring correct installation of the KABER AKTIV system. He is best
placed to provide information, address your queries and resolve any problems. If this is not possible,
please contact the Linn Products factory in Scotland, or your national distributor. For your information
some tips regarding positioning, electrical supplies and interconnections are listed below.
KELTIK loudspeakers with fitted stands
KELTIK AKTIV Crossover Unit
Mains Lead
Owner Manual and registration card
3 Pairs Phono to Cannon leads
1 Pair Phono to Phono leads
Spare Fuse
Set of Labels
Resistor Pack (for installation use only)
WARNING Use the earth moulded mains lead supplied. Never use an unearthed plug or adapter.
WARNING
THIS APPLIANCE MUST BE EARTHED
IMPORTANT
The wires in this mains lead are coloured in accordance with the following code:
Green-and-yellow: Earth
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows:
The wire coloured green-and-yellow must be connected to the terminal in the plug, which is marked with
the letter E or by the earth symbol or coloured green or green-and-yellow.
The wire coloured blue must be connected to the terminal which is marked with the letter N or coloured
black.
The wire coloured brown must be connected to the terminal which is marked with the letter L or coloured
red.
To Next Page
Loading...