RANSPORTATION
If installation by the retailer
is impossible, the deck may be taken by the
customer. In this case, the outer platter must be
removed and placed in the bottom packing tray and the
inner platter removed and placed in the top tray. The
counterweight should be removed from the arm.
The deck should be pre-packed in it’s original packing
†
,
with the arm and cartridge removed, when it has to be
shipped anywhere. Under no circumstances should the
deck be shipped with the arm fitted to the turntable. The
red bearing cap should be fitted to prevent oil spillage -
see diagram of the packing assembly.
†
Note: When re-packing the turntable, remove the two bottom cover screws, which
are located between the turntable feet. If these screws are left in position during
shipping, they will damage the rim of the platter.
T
To Next Page
Loading...
