NSTALLATION In most cases, installation of
the LP12 will be completed by the retailer, but
the following points should be noted:-
FLOOR MOUNTING. Place the deck on a small, light,
rigid table, e.g., small coffee table. Ensure that the table
is sitting level on the floor and not rocking.
WALL MOUNTING. Wall mounting may be preferable
where a highly sprung floor exists or where there is risk
of damage by children. The shelf used should be light
and rigid, and it should be fully supported by, but not
firmly screwed or glued to it’s brackets.
To allow the lid to open fully, a clearance of 3” (7.5cm)
is required behind the plinth and at least 13” (33cm)
above.
It is quite normal for the deck suspension to settle
slightly after installation. This will not affect
performance.
I
To Next Page
Loading...
