19
TrainMaster Command Control operations
CAB-1 Remote Controller commands
T
he CAB-1 Remote Controller commands are detailed below. The corresponding RailSounds
sound system effects are in bold italic type.
Releases the ElectroCoupler on the rear of the
tender. Coupler release sound.
Activates the numeric keypad.
Short steam release sound.
Controls switch direction. Toggles all lights on/off,
except lights that are wired to track power.
Accelerates the locomotive with a clockwise
rotation. Decelerates the locomotive with a
counter-clockwise rotation. Speed-dependent
chuffing sounds. DynaChuff dynamic chuffing
effect.
Activates the locomotive’s whistle. Release the
button to discontinue the sound. Whistle sound
with steam effect.
When a LEGACY locomotive is on the track,
hold down the set key and press whistle. You
will hear two beeps. Your locomotive will
produce a quilling whistle.
Toggles the bell sound on and off.
Bell sound.
Changes the locomotive’s direction. The locomotive
decelerates to a stop and continues in the opposite
direction when you increase the throttle. Air release
sound.
Increases the locomotive’s speed while the button is
pressed. Release the button to return to the initial
speed. Labored chuff.
Decreases the locomotive’s speed while the button is
pressed. Squealing brake sounds.
Shuts down all PowerMasters on your railroad. Stops
all TrainMaster Command Control-equipped locomotives
in operation. Use HALT only in emergency situations.
Odyssey II Momentum
L 32 speed steps with low
momentum
M 100 speed steps with low
momentum
H 100 speed steps with medium
momentum
Note!
To Next Page
Loading...
