Lionel FEF-3 - Insalling the O Gauge Front Coupler

29
Maintaining and servicing your locomotive
Bottom
Figure 11. Installing the “O” gauge coupler
C
arefully turn your locomotive over and remove the screw holding the scale coupler with
a small Philips head screwdriver. Remove the scale coupler and coupler door from the
locomotive and store in a safe spot for possible reassembly later.
Position the “O” gauge coupler and secure with the previously removed screw. Refer to
Figure 11. Note that the coupler door cannot be installed when using the “O” gauge coupler.
Installing the “O” gauge front coupler