23
Locking your locomotive into a single direction
W
hen the Command reverse unit switch is in the RUN position, your locomotive sequences
through a repeating pattern of operations: forward, neutral, reverse, neutral, and so on.
To “lock” your locomotive into a single direction (for example, to operate in forward
only), you can deactivate the Command reverse unit’s sequencing function.
1. Use your transformer’s DIRECTION button or interruptions in track power
to get your locomotive moving slowly in the desired direction or into
neutral.
2. Slide the Command reverse unit switch to the PROG position. At this point,
the locomotive is “locked” into your chosen direction. See Figure 6 on
page 8 for the location of this switch.
To restore the forward-neutral-reverse sequence, just slide the Command reverse unit
switch back to the RUN position.
Because of the way that speed control operates in conventional mode, you will
notice a slight delay between adjusting your transformer throttle and the change
in the speed of your locomotive. If you desire instantaneous response to throttle
changes, turn off the Odyssey II Speed Control system using the Odyssey II Speed
Control switch (see Figure 6 on page 9.)
Conventional transformer operations
Note!
To Next Page
Loading...
