III,.
Is CAB-l speaking to PowerMaster?
Press TRACK, "1" on the Ill-digit key-
pad, then any command button. This
reestablishes communication with any
factory-programmed PowerMaster.
III,.
Press BC:X:>ST;this reactivates a shut-
down PowerMaster.
"" Turn off any interfering electronic
devices in your railroad area: televisions,
computers, and CB radios.
"" Relocate PowerMaster to a more
accessible location in your train area.
III,.
Reprogram PowerMaster. Slide the
RUN / PROGRAM switch to
Program.
Press TRACK ("TR") and your num-
ber choice from the la-digit keypad.
Slide the switch back to RUN. Press TR,
the number, and DIRECTION; Power-
Master should respond with a flashing
red light.
III,.
Check the frequency crystals inside
CAB-l and PowerMaster. They should
be installed with a snug fit.
Plug Big Red's wire into the jack located
on the top ofCAB-l.
on the top edge of CAB-l and plug in
Big Red's wire. You're now ready for
Big Red locomotive operations.
Answers to questions
THE GREEN LIGHT
IS
OFF
III,.
Plug in PowerHouse and turn it on.
Check PowerHouse's circuit breaker'
push it in if it's been triggered. '
"" Make sure PowerHouse's connect-
ing wire is secured
firmly
in Power-
Master's input. PowerMaster's green
light should illuminate.
I
WANT TO PUT ANOTHER LOCO-
MOTIVE
ON
TRACK
"" Address the block of track your loco-
motive will occupy. Deactivate it by
pressing AUXI and "0" on the Ifl-digit
keypad. Reestablish power by pressing
BOOST.
III,.
The stall voltage should be checked
and reset if necessary.
THE GREEN LIGHT
IS
FLASHING
11,* There's a' short-circuit across the
track PowerMaster is controlling.
Check for derailments or other short cir-
cuits. Reset PowerMaster by pressing
BOOST.
THE RED LIGHT DOESN'T FLASH
III,.
Check the alkaline batteries in CAB-
1for freshness and proper installation.
When CAB-l isproperly powered, you'll
hear a small" clicking" sound with every
button press.
III,.
Extend the telescoping antenna com-
pletely.
THE LOCOMOTIVE WON'T MOVE
111I. CAB-l may be asleep. Press BOOST.
1111. Check the connections between
PowerMaster and your track. TheA wire
should connect to the center rail; the U
wire attaches to an outside rail.
III,.
If your locomotive derailed, Pow-
erMaster's short-circuit protection may
have been activated. When PowerMaster
16
Lionel TrainMaster
Lionel TrainMaster
17
To Next Page
Loading...