Lionelo Antoon Plus - Installation in the Car

‑ 10 ‑EN
3. Pull the seat inclinaon lever (12) and lt the child safety seat to the posion 5. It is
a lying posion intended for babies.
NEWBORN INLAY
The newborn inlay is intended for babies, improves their comfort and provides addional
support (see: 1 in g. 12). If the child needs more space in the child safety seat, remove the
newborn inlay.
✓
40-75cm
✗
>75cm
HOW TO REMOVE THE COVERING
1.
Remove the 5-point belts of the child safety seat (see: HOW TO DISASSEMBLE CHILD
SAFETY SEAT BELTS).
2. Remove child safety seat covering from the backrest and base.
3. Li the headrest as high as you can.
4. Remove covering from the headrest.
To put the cover back on, retake the aforesaid acons in reversed order.
HOW TO ADJUST THE SUPPORT LEG
1. Press the support leg adjustment buon (20), keep it pressed and pull out the leg with
another hand at the same me (g. 18).
2. Release the adjustment buon only when the support leg touches the oor.
3. Make sure it has been posioned properly, try to move it.
The support leg fastener indicator (9) should be green. If it is not the case, repeat the
procedure once again.
Note! If there is any oor locker in your car, contact the manufacturer!
Installaon in the car
REAR-FACING POSITION (40 – 105 cm)
ISOFIX + support leg
See: g. 19
1.
If necessary, put ISOFIX pads (22) on ISOFIX connectors in the car. They help you sck
ISOFIX connectors when car connectors are hard to access.
2. Rotate the child safety seat to reach the rear-facing posion (see: HOW TO ROTATE