Lippert Components Solera Power Awning - System Information

Rev: 09.05.18 Page 2 CCD-0002116
TI-275
SOLERA
®
POWER AWNING HEAD REPLACEMENT
AWNINGS
Instructions
Removal
1. Extend the awning about 12" away from the unit.
2. Secure both support arm assemblies by running a zip tie around the outer arm and around the pin on
the top of the mount arm where the mount arm and inner arm connect (Fig. 1).
Fig. 1
3. Remove the wax screw (Fig. 2A) from the end cap (Fig. 2B) that attaches to the shaft (Fig. 2C) on the
drive head assembly.
4. Support the roll tube (Fig. 2D) to prevent it from falling and damaging the side of the coach.
5. Remove the drive head assembly retaining bolt (Fig. 2E) from the outer arm.
6. Remove the roll tube from the drive head shaft and the drive head assembly from the outer arm.
7. Disconnect the wires. Remember the orientation of the colored wires.
Installation
NOTE: If current drive head uses an old harness with spade connectors, a new power wire will need to be
installed. If necessary, connect the new power wire to the new drive head prior to beginning the
installation process.
1. Connect the wiring and slide the drive head into the outer arm. Be careful not to pinch the wiring
between the drive head assembly and the outer arm.
2. Secure the drive head assembly in the outer arm with the drive head assembly retaining bolt (Fig. 2A).
3. Insert the drive head assembly shaft (Fig. 2B) into the roll tube end cap (Fig. 2C).
4. Replace the wax screw (Fig. 2D) in the roll tube end cap.
NOTE: When securing the wax screw, leave approximately
⁄
" between the screw head and the roll tube,
as overtightening will strip the screw.
5. Remove zip ties.