Lippert Components SolidStep 3.0 - Operating the SolidStep; Extend SolidStep; Store SolidStep; Adjust Step Leg Extensions

tv
7
lci1.com 574-537-8900 Rev: 02.10.20
CCD-0002548
SolidStep
®
3.0
Adjustable Latch
Installation and Owner’s Manual
(For Aftermarket Applications)
B
A
C
Fig.8
Operation
Extend Steps
1. Disengage transport lock.
2. Firmly grasp and pull out the vertically stored SolidStep
and rmly rest it on the ground.
Storage of Steps
1. Lift up SolidStep to its stored position and make sure the
transport lock has been engaged.
Leg Extension Adjustment
The leg extension is secured with a quick release clevis
pin. Adjustments can be made to the leg extensions in 1”
increments by extending or retracting the inner leg for the
optimal angle, and to adjust for the ground surface angle.
1. To extend the inner leg (Fig.8A):
A. Remove the quick release clevis pin (Fig.8B) from the
tube and the slot in the angle.
B. Extend the inner leg (Fig.8A) to the ground and at an
angle so the steps are parallel to the ground and level.
Reinsert the quick release clevis pin (Fig.8B) into the tube
and slot closest to where the inner leg and tube (Fig.8C)
meet.
2. To retract the inner leg (Fig.8A):
A. Remove the quick release clevis pin (Fig.8B) from the
tube and slot.
B. Retract the inner leg.
C. Insert the quick release clevis pin in the tube and slot.