Rev: 08.31.23 Page 3 CCD-0007174
The "WARNING" symbol above is a sign that a procedure has a safety risk involved and may cause
death or serious personal injury if not performed safely and within the parameters set forth in this
manual.
Failure to follow instructions provided in this manual may result in death, serious personal injury
and/or severe product and property damage, including voiding of the component warranty.
Moving parts can pinch, crush or cut. Keep clear and use caution.
The “CAUTION” symbol above is a sign that a safety risk is involved and may cause personal injury
and/or product or property damage if not safely adhered to and within the parameters set forth
in this manual.
Safety
Read and understand all instructions before installing or operating this product. Adhere to all safety labels.
This manual provides general instructions. Many variables can change the circumstances of the instructions,
i.e., the degree of difficulty, operation and ability of the individual performing the instructions. This
manual cannot begin to plot out instructions for every possibility, but provides the general instructions, as
necessary, for effectively interfacing with the device, product or system. Failure to correctly install, remove
or service the system may result in voiding the warranty, inflicting injury or even death.
Resources Required
• 1-2 persons, depending on task
• Fastening hardware, OEM-supplied
• Tabletop material
• Cordless or electric drill
• Appropriate drill bits
• Appropriate drive bits
• Appropriate-sized open-end wrench
• Appropriate-sized hex wrench
• Screwdriver
• Tape measure
• Pencil
Always wear eye protection when performing service, maintenance or installation procedures.
Other safety equipment to consider would be hearing protection, gloves and possibly a full face
shield, depending on the nature of the task.
To Next Page
Loading...
