10
lippert.com 432-LIPPERT (432-547-7378) Rev: 10.18.22
Flow Max
™
RV Toilet
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0004230
2. If step 1 does not fully clean the ball and seal, clean with
a soft bristle brush and non-abrasive toilet bowl cleaner.
3. Fully clean the top of the ush ball and under the
seal where it contacts the ush ball. After cleaning the
underside of the seal, apply light, downward pressure to
the top of the seal while brushing around the full perimeter
of the seal.
NOTE: If the ball pivot arm becomes dislodged while
cleaning inside the base beneath the flush ball and seal,
re-engage it into the pivot point.
Maintenance
Properly cleaning, winterizing, and maintaining your toilet
will increase its lifespan.
• Do not separate the ceramic bowl from the plastic base.
The bowl and base of the toilet should not be separated
for any reason.
• Do not remove the flush pedal from the base. This toilet
has a factory-sealed bowl-to-base assembly.
• Do not disassemble the components.
NOTE: The toilet does not need to be removed from the
vehicle (or unfastened from the floor) for basic repairs.
Performing Routine Toilet Cleaning
Use a non-abrasive bathroom and toilet bowl cleaner for
routine cleaning. Follow label instructions on cleaning
solutions.
IF THIS TOILET EVER REQUIRES SERVICE, READ
THE FOLLOWING STATEMENTS BEFORE SERVICING
THE PRODUCT. FAILURE TO FOLLOW THESE
GUIDELINES CAN CAUSE PRODUCT DAMAGE AND
CAN VOID YOUR WARRANTY COVERAGE.
Cleaning the Flush Ball and Seal
After a period of time, mineral deposits from hard water
may build up on the flush ball or seal, resulting in a slow
water leak. To prevent this, periodically clean the flush ball
and seal.
1. Remove minor debris from the ush ball and seal (Fig.9)
by slowly depressing and releasing the ush pedal several
times. This will loosen and rinse debris from the surfaces.
Repeat several times for stubborn build-up.
Fig.9
Flush Ball
Seal
Flush Pedal
Holding Tank
To Next Page
Loading...