Rev: 08.19.21 Page 2 CCD-0004029
TABLE OF CONTENTS
Introduction 2
Safety 2
Resources Required 2
Installation 3
Camera Setup (If applicable) 4
Operation 9
Troubleshooting 10
Camera reset 10
Introduction
The Lippert Insight™ Back-up Camera is a 12V camera that streams wireless video to a mobile device using
the OneControl application showing the rear view of the trailer.
Images used in this document are for reference only when assembling, installing and/or operating this
product. Actual appearance of provided and/or purchased parts and assemblies differ.
For information on the assembly or individual components of this product, please visit:
https://support.lci1.com/electronics/
Safety
Read and understand all instructions before installing or operating this product. Adhere to all safety labels.
This manual provides general instructions. Many variables can change the circumstances of the instructions,
i.e., the degree of difficulty, operation and ability of the individual performing the instructions. This
manual cannot begin to plot out instructions for every possibility, but provides the general instructions,
as necessary, for effectively interfacing with the device, product or system. Failure to correctly follow the
provided instructions may result in death, serious personal injury, severe product and/or property damage,
including voiding of the Lippert limited warranty.
The "WARNING" symbol above is a sign that a procedure has a safety risk involved and may cause
death or serious personal injury if not performed safely and within the parameters set forth in
this manual.
The “CAUTION” symbol above is a sign that a safety risk is involved and may cause personal injury
and/or product or property damage if not safely adhered to and within the parameters set forth
in this manual.
Resources Required
• Ladder
• Mobile device
• #8 panhead screws of appropriate length
• Wire strippers (if needed)
• All-weather silicone sealant
To Next Page
Loading...