Lippert On-the-Go - Introduction; Safety; Resources Required

Rev: 06.30.22 Page 2 CCD-0004502
TABLE OF CONTENTS
Introduction 2
Safety 2
Resources Required 2
Installation 3
Prior to Installation 3
Receiver Installation 3
Additional Instructions 4
Ladder Operation Verication 4
Overview 4
Extending and Retracting the Ladder 5
Installing Ladder on Receiver 6
Essential Ladder Operation Safety 7
Storage 7
Introduction
The On-the-Go Receiver is designed for easy installation on various types of units. The receiver is designed for
use with both the 12.5 ft and 14.5 ft versions of the On-the-Go Ladder. No pre-drilling is required for installation.
The "WARNING" symbol above is a sign that a procedure has a safety risk involved and may cause death or
serious personal injury if not performed safely and within the parameters set forth in this manual.
Failure to follow instructions provided in this manual may result in death, serious personal injury
and/or severe product and property damage, including voiding of the component warranty.
Always wear eye protection when performing service, maintenance or installation procedures.
Other safety equipment to consider would be hearing protection, gloves and possibly a full face
shield, depending on the nature of the task.
The “CAUTION” symbol above is a sign that a safety risk is involved and may cause personal injury
and/or product or property damage if not safely adhered to and within the parameters set forth
in this manual.
Safety
Read and understand all instructions before installing or operating this product. Adhere to all safety labels.
This manual provides general instructions. Many variables can change the circumstances of the instructions,
i.e., the degree of difficulty, operation and ability of the individual performing the instructions. This
manual cannot begin to plot out instructions for every possibility, but provides the general instructions,
as necessary, for effectively interfacing with the device, product or system. Failure to correctly follow the
provided instructions may result in death, serious personal injury, severe product and/or property damage,
including voiding of the Lippert limited warranty.
Resources Required
• Cordless or electric drill or screw gun
• Appropriate drive bits
• Ladder or step ladder
• Butyl tape
• Ruler or tape measure
• Non-permanent marking method