Lippert On-the-Go - Installing Ladder on Receiver

Rev: 06.30.22 Page 6 CCD-0004502
Fig. 8
Installing Ladder on Receiver
1. Extend the ladder to full height.
2. Insert the attached mounting hanger of the ladder into the slots of the receiver (Fig. 8).
75°
3. Pull down on the ladder to make sure the mounting hanger is fully inserted into the receiver.
4. Put the feet of the ladder on the ground. Ladder should be at an angle. The optimal angle for use of
the ladder is approximately 75 degrees (Fig. 9). Retract rungs starting from the bottom if angle
needs adjustment.
Make sure ladder is fully seated in the receiver before use. If all the ladder treads are not fully extended,
use caution ascending and descending as ladder rung spacing will not be as uniform as expected.
Fig. 9