Rev: 06.30.22 Page 4 CCD-0004502
Additional Instructions
Ladder Operation Verification
These instructions are needed if a complete On-the-Go Ladder system is provided by the OEM. Use the
following instructions to verify ladder operation.
locked
unlocked
Overview
Each ladder rung is extended and retracted via telescoping rails held in place by locks and operated by sliding
the lock buttons (Fig. 2A). Sliding the button towards the rail engages the lock. Sliding the button away from
the rail disengages the lock (Fig. 3).
The ladder can be fully retracted when the ladder is being stored, or fully extended during use if the full
height of the ladder is required (Fig. 4).
NOTE: The ladder can be used under a partial extension in the event that the full ladder height is not
needed. Care should be taken to ensure that rung spacing is even to avoid potential for tripping, or
else group unused rungs at either the top or the bottom of the ladder.
A
Fig. 2
Fig. 3
Lock Button
Full Retraction Full Extension
Fig. 4
Remove and stow the ladder prior to travel. Failure to properly remove and stow the ladder
could result in personal injury or property damage.
To Next Page
Loading...