Rev: 12.27.22 Page 10 CCD-0007002
Troubleshooting
Manual Override
In the event of power loss or motor failure, the awning can be extended or retracted manually. Perform the
following procedure to manually extend or retract the awning.
NOTE: This procedure may also be performed to extend or retract the awning in the event of dry camping
or camping without a battery.
1. Remove the rubber grommet (Fig. 14A) from the drive head assembly, exposing the manual override
nut on the motor.
NOTE: The drive head assembly is always located on the right side of the awning as it is viewed from
outside of the unit.
2. Using a
⁄
" socket and cordless power drill, spin the manual override nut (Fig. 15A) clockwise to
extend (Fig. 15B) or counterclockwise to retract (Fig. 15C) the awning.
NOTE: Use caution when extending or retracting the awning manually. The use of a step stool or ladder
may be required to completely extend or retract the awning.
3. When the awning is completely extended or retracted, remove socket or drive device and replace the
rubber grommet (Fig. 15D) in the drive head assembly.
A
Fig. 14 Fig. 15
D
C
A
B
To Next Page
Loading...