Rev: 12.27.22 Page 8 CCD-0007002
Extending the Awning with the Power Button Switch
NOTE: Some units may not use the Lippert switch (Fig. 9).
1. Verify the unit battery is fully charged and connected to the electrical system.
NOTE: If the unit is equipped with a locking latch, be sure to unlock the latch prior to extending the awning.
2. Press and hold EXTEND (Fig. 9A) until the awning is extended completely.
NOTE: Extension is considered complete when the fabric is completely unrolled, the valance seam is visible
and a section of the roll tube is exposed (Fig. 10).
NOTE: The awning fabric should always be above the roll tube. However, if the extend switch is engaged
too long or extend is hit inadvertently instead of retract, the awning will roll up backward. This is not
a defect. To correct the fabric orientation, press the RETRACT button. The awning will then extend to
its correct orientation and normal operation can resume.
Retracting the Awning with the Power Button Switch
NOTE: Some units may not use the Lippert switch (Fig. 9).
1. Verify the unit's battery is fully charged and connected to the electrical system.
NOTE: The awning can be retracted without resetting the pitch.
2. Press and hold RETRACT (Fig. 9B) until the awning is retracted completely.
Tying down the roll tube once the awning is extended will not allow the free-oating support arms
and the wind sensor to work as designed and may cause damage to the awning or Unit.
A
B
Valance Seam
Exposed Roll
Tube Section
Fabric
Roll
Tube
Valance
Awning
Head
Fig. 9
Fig. 10
Warning Chime - If the awning is paired to the OneControl app, during the automatic closure
due to a wind event, a warning chime will sound. This is intended to warn users to stand clear
as the awning retracts.
NOTE: The awning may automatically retract if the wind sensor is activated.
NOTE: If the unit is equipped with a locking latch, be sure to engage the latch after retracting the awning.
To Next Page
Loading...