Rev: 12.27.22 Page 4 CCD-0007002
Syncing the Bluetooth® Wind Sensor to the One Control App
Located on the outside of the drive side arm will be a QR label (Fig. 1A). The QR label is also located inside
the owner's manual (Fig. 1B), or on the wind sensor (Fig. 1C) located on the inside of the drive side arm
should the front of the arm sticker wear off or the manual is lost. Scan the QR code when ready to pair to the
OneControl application.
Fig. 1
C
2. Open the app and either register or log in.
When on, the automatic retraction due to wind feature will operate without any other inputs.
If people are between the awning arm and the frame, they will be injured. The awning will sound an
audible chime before starting a wind-triggered auto-retraction and continue to time as it retracts.
This is intended to draw attention of people who may be between the awning arm to give them time
to get clear. When the automatic retraction due to wind feature is on, never hang objects from your
awning. When the awning retracts, those objects and your awning will be damaged.
Preparation - Initial Pairing of the Wind Sensor to the OneControl App
The wind sensor MUST be activated by the OneControl application in order for the wind sensor to operate.
Resources Required
• Android, iOS smart device
• Internet connection
1. To get started, if you have not already downloaded the Lippert OneControl App to control your
Bluetooth® unit devices, scan the QR code below for your smart device.
A
B
To Next Page
Loading...