3
lippert.com 432-LIPPERT (432-547-7378) Rev:06.02.23
Solera
®
Awning Polycord
Fabric Replacement
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0003784
Removal
1. Remove the drip cap (if equipped) from the end which
the fabric will be removed.
2. Fully extend the awning.
3. Disconnect power to any fabric LED lights in the support
arm assembly or remove the fabric LED light strip from the
polycord of the fabric.
4. Retract the awning until there is approximately 12”
remain visible.
5. Secure both support arm assemblies by running a zip
tie around the outer arm and around the pin on the top
of the mount arm where the mount arm and inner arm
connect, (Fig.1A).
6. Remove the screws holding the polycord in place on the
awning rail.
7. Remove the wax screws holding the end caps onto the
drive and idler head shafts, (Fig.2).
FAILURE TO SUPPORT THE ROLL TUBE, FABRIC
AND DRIVE/IDLER HEAD ASSEMBLIES DURING
REMOVAL MAY RESULT IN SERIOUS INJURY OR
PROPERTY DAMAGE.
Fig.1
8. Place the roll tube and fabric on a clean, level surface
that is free of any debris able to scratch or damage the roll
tube and/or fabric.
9. Remove the end cap from the end of the roll tube from
which the fabric will be removed.
10. With one person holding the end of the fabric that gets
attached to the awning rail on the unit, another can rotate
the roll tube to unroll the fabric until only the polycords are
left on the roll tube.
11. Remove the screws holding the polycord in place on
the roll tube.
12. To remove the fabric, gently pull the roll tube from one
end, while another person holds the fabric in place.
Fig.2
A
To Next Page
Loading...
