5
lippert.com 432-LIPPERT (432-547-7378) Rev:06.02.23
Solera
®
Awning Polycord
Fabric Replacement
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0003784
9. Secure the fabric in the awning rail no more than 1”
inside the edge of the fabric on both ends using a #6 x ½”
hex head screw. Install the screw down through the awning
rail into the fabric and the polycord, (Fig.5).
awning rail
1”
Fig.5
10. Install the screw (Fig.6A) that was holding the
polycord (Fig.6B) in place on the roll tube. Between
the edge of the fabric (Fig.6C) and the stitching on the
hem. The screw should NOT go through the fabric.
11. Reinstall the drip cap (if previously equipped).
12. Reconnect any light wiring as needed.
NOTE: The fabric LED light strip will need to be installed
on the polycord of the fabric prior to connecting any wiring
previously removed.
Maintenance
Resources Required:
• 5-gallon bucket
• Clean water
• Soft bristle brush with sufficient reach
• ¼ cup of dish soap
Fabric Care
If the awning is retracted while wet, extend it and let it dry
as soon as conditions allow before retracting again. This
will help prevent the formation of mildew and add greatly to
the life of the awning. Mildew does not form on the fabric
itself, but on the accumulated dust, dirt and grime.
Cleaning Awning
Periodically clean vinyl or woven acrylic fabric using a
mixture of ¼ cup of dish soap and 5-gallons of warm
water. Liberally apply the mixture on the top of the fabric
and retract the awning for 5 minutes. This will apply the
mixture to the bottom of the fabric as well. Extend the
awning and hose off with fresh water. Repeat if necessary.
Allow to dry before retracting.
OVER-SPRAY OF CLEANING SOLUTION CAN CAUSE
EYE AND SENSITIVE SKIN IRRITATION. FLUSH
AFFECTED AREA WITH CLEAN WATER AND SEEK
MEDICAL ATTENTION, IF NECESSARY. WEAR EYE
PROTECTION AND APPROPRIATE PROTECTIVE
CLOTHING TO AVOID PERSONAL INJURY.
B
A
C
Fig.6
To Next Page
Loading...
