4
lippert.com 432-LIPPERT (432-547-7378) Rev:06.02.23
Solera
®
Awning Polycord
Fabric Replacement
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0003784
Installation
1. Unroll the replacement fabric over the old fabric so
that the cord is parallel with the roll tube and to prevent
scratching the fabric.
NOTE: The replacement fabric only has ONE polycord that
inserts into the roll tube.
2. On a clean, level surface free of any debris that could
scratch or damage the roll tube, gently slide the roll tube
onto the polycord of the fabric, making sure that the non-
printed side is touching the roll tube, (Fig.3).
3. Center the fabric on the roll tube.
4. Roll the fabric onto the roll tube, (Fig.4). and reinstall the
fabric screw into the roll tube. Make sure the fabric stays
snug and at to the roll tube with the printed side facing
away from the tube.
FAILURE TO MAINTAIN CONTROL OF THE ROLL
TUBE, FABRIC AND DRIVE/IDLER HEAD MAY
RESULT IN SERIOUS INJURY OR PROPERTY
DAMAGE.
5. Reinstall the end cap previously removed.
6. With help from another person, install the roll tube and
fabric on the awning rail and support arms, making sure
the awning will unroll with the color of the fabric facing up.
7. With help from another person, slide the head on the
assembly shaft into the end cap. Install the wax screws
at each end to secure the roll tube end caps to the head
assemblies.
NOTE: It is suggested to keep the head of the wax screw
1/8” from being fastened flush so as not to compromise the
structural integrity of the wax screw.
8. Extend and retract the awning several times to make
sure that the fabric is square on the roll tube.
Fabric
Fig.3
Polycord in Roll
Tube Channel
Slide
fabric
roll tube
roll
valance
Fig.4
To Next Page
Loading...
