3
lippert.com 432-LIPPERT (432-547-7378) Rev: 01.28.22
Tire Linc
™
LCD Display
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0004222
Installation
To install the LCD handheld display stand:
1. Make sure to have a clean, level, nonporous surface for
the stand's suction base to adhere to.
2. Lift the locking lever located at the bass of the
mounting arm.
3. Set the stand's suction base over the clean area
then press down on the locking lever to mount the LCD
handheld display stand in-place.
If desired, the LCD handheld display can be mounted to
the display stand by pressing the mounting pocket on the
back of the handheld display onto the mounting bulb of
the stand.
Message To Power Off Displays
Whenever a user accesses one of two modes in the
Settings menu — Learn All Sensors or Learn A Sensor
— a screen will appear on the display for five seconds
(Fig.1) before automatically transitioning to the notifications
received before sensor learning takes place. This screen will
also appear after the user selects whether a spare tire is to
be added or not.
Pairing, Configuration
NOTE: Pair Mode is usually not necessary for the display
to pair to the repeater. Pair Mode is needed only when
attempting to pair the display to the repeater and more
than one repeater is located nearby. When the repeater
is in Pair Mode, the BLE (Bluetooth Low Energy) name
TireLinc changes to TireLinc*.
Place Repeater Into Pair Mode
1. If Pair Mode is needed, press and hold the Pair Mode
button on the repeater (Fig.2B) until there is one long
red blink followed by two short red blinks. This takes
approximately ve seconds.
2. Release the button.
A
B
Sensor Pairing
3. Turn on LCD display using On/O button on bottom of
the display (Fig.3).
4. Tap the Scan for New Bluetooth Devices arrow (Fig.4)
and look for the TireLinc listing.
NOTE: If the repeater is in Pair Mode, look for TireLinc*.
5. Select the rst listing (Fig.5) and tap CONTINUE.
Fig.1
Fig.2
To Next Page
Loading...