Lippert Tire Linc 2020114605 - Tire Linc Threshold Configuration; Setting Pressure and Temperature Limits; Tire Linc Individual Sensor Learning; Learning a Single Sensor

8
lippert.com 432-LIPPERT (432-547-7378) Rev: 01.28.22
Tire Linc
™
LCD Display
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0004222
Configure All Thresholds
1. Before accessing the SETTINGS menu, check to make
sure the vehicle selected to have thresholds congured is
present on the main tire pressure screen.
2. Select the Congure All Thresholds arrow on the
SETTINGS screen (Fig.17A).
A
Fig.17
Fig.18
Fig.16
7. When pairing has been completed, the display will ask
if another vehicle is to be added to the system (Fig.16). If
tapping YES, pair the additional sensors in the proper
sequence. If not, continue to Congure All Thresholds.
NOTE: There are limits of three vehicles and 20 tires.
3. Set the Minimum Pressure, Maximum Pressure,
Maximum Temperature and Maximum Temp Change for
the sensors (Fig.18). After each selection, tap FINISH.
Learn A Sensor
1. Before accessing the SETTINGS menu, check to make
sure the vehicle on which a sensor is to be learned is
present on the main tire pressure screen.
2. Tap the arrow to the right of Learn A Sensor (Fig.19A).
A
Fig.19