9
lippert.com 432-LIPPERT (432-547-7378) Rev: 01.28.22
Tire Linc
™
LCD Display
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0004222
3. A notification will appear on the display for 5 seconds
(Fig.20) instructing you to turn off all other displays
connected to your repeater before automatically
transitioning to the notifications received before sensor
learning takes place.
A
A
Fig.20
Fig.21
Fig.22
4. The vehicle will at rst appear without a red blinking dot.
Select the tire with a sensor to be learned (Fig.21A) and
observe a red blinking dot on that tire (Fig.22A).
NOTE: The procedure for learning a sensor is the same as
relearning sensors.
5. Hold the LCD display close to the sidewall in the area
opposite the valve stem of the tire to be paired (Fig.23).
6. Press and hold the sync button on the LCD display
(Fig.3) to pair the sensor until the display beeps and the red
ashing circle turns green.
Fig.23
7. If you are using external stem sensors:
A. Screw the sensor onto the valve stem until
securely fastened.
B. Watch the display until the flashing circle turns green.
NOTE: This may take up to 90 seconds.
C. If the sensor does not show as learned within 90
seconds, unscrew the sensor for 10 seconds then screw it
back onto the valve stem to reattempt learning the sensor.
8. The display will feature a red dot representing the tire
that is being paired, which will then turn green when it is
successfully paired.
To Next Page
Loading...