M & MA Series Meters
34
Get the latest PDF manual:
https://www.lcmeter.com/resources/technical/manuals
Mobile/online version of this manual:
https://www.lcmeter.com/manuals
3. With a plastic or non-metallic mallet, tap on the heads of the screws on the rotor ends
lightly and equally, slowly driving the rotors off of the rotor gears. As you tap on the
screws, the rear bearing plate and the rotor assembly will separate from the housing.
NOTE: For carbon insert bearing plates, remove the rear plate first and then each rotor
as it is hand supported.
4. Use the bearing plate wrench (or a socket driver) to remove the screws that hold the
front bearing plate to the meter housing. The number of screws will vary depending on
meter size.
To Next Page
Loading...
Need help?
General
