Why doesn't the register record correctly when product flows through Liquid Controls Measuring Instruments?
If product flows through the Liquid Controls Measuring Instruments meter, but the register does not record correctly, it may be caused by an adjuster not properly calibrated, an incorrect gear plate or gear ratio being installed, or air being in the system.
General readiness steps before operating the meter, including reading instructions and using proper equipment.
Procedures for safely relieving pressure and draining liquid from the system before disassembly.
Critical steps, codes, and precautions necessary for correct meter installation.
Essential guidelines and conditions for operating the meter correctly to ensure performance and safety.
Procedures and cautions for safely priming, starting up, and operating the meter.
Key considerations and precautions for performing meter maintenance, including pipe strain and storage.
Step-by-step guide for taking apart the meter, including rotor gears and bearing plates.
Instructions for correctly putting the meter back together, including rotor timing and cover tightening.
General| Model | M-25 |
|---|---|
| Category | Measuring Instruments |
| Type | Positive Displacement Flow Meter |
| Operating Pressure | 150 PSI |
| Pressure Rating | 150 PSI |
| Operating Temperature | -40°F to +160°F |
| Temperature Range | -40°F to +160°F (-40°C to +71°C) |
| Materials of Construction | Aluminum, Stainless Steel |
| Output | Pulse |
To Next Page
