lissLights Spright Motion - Setting Up The BlissLights Spright Motion; Ground Stake Accessory; Floor Stand Accessory

3
Before operating your Spright Motion, please read the “Before you Begin” section and “Notice” section of this
user guide.
INSTALLATION TIPS
• Do not connect the light to a dimmer pack, as a dimmer accessory may damage
the laser component.
• Use only the manufacturer-provided power supply. You may plug your BlissLight into
any ordinary 110/120V AC electrical outlet indoor or outdoor.
• Limit the use of extension cords. If you need an extension cord, use only UL, CUL, or
CSA approved 3rd party extension cords. When using outdoors, ONLY use extension
cords that are weather resistant, such as waterproof cords.
• The darker the display area the brighter your projection will appear. Try to avoid
display areas with strong ambient light sources, such as commercial street lights or
bright security ood lights.
• If you are going to mount the BlissLights Spright Motion for downlighting (e.g. from
balcony railing, fence line, roof line, etc.), it is recommended that, for safety purposes,
your lights are properly mounted using a suitable hanging clamp and safety cable.
SETTING UP THE BLISSLIGHTS SPRIGHT MOTION
GROUND STAKE ACCESSORY: Use the included ground
stake when placing and positioning the xture into
the soft earth outdoors. Simply stake the BlissLights
Spright Motion into the desired location holding the
top of the ground stake and gently piercing the stake
into the ground. Do not grasp xture head when
staking your BlissLight into the ground. Attach
the stake to the xture head by twisting xture
clockwise, and remove the stake by twisting xture
counterclockwise. Adjust the angle of projected light
by turning the thumbscrew attached to the side of
the xture.
FLOOR STAND ACCESSORY: Use the included stand as a
quick and easy alternative to the ground stake when
placing and positioning the xture on any hard, at
surface area indoors (i.e. oor, window sill, top of
cabinet, inside staircase or bookshelf) or outdoors (i.e.
porch, sidewalk, patio table, deck). Attach the stand
to the xture head by twisting xture clockwise, and
remove stand by twisting xture counterclockwise.
Adjust the angle of projected light by turning the
thumbscrew attached to the side of the xture.