31
8. Troubleshooting table
Error Cause Remedy
Motor does not start
Feed lever (Pos. 20) not in the
middle position
Move the lever (Pos. 20) into the
middle position
Emergency stop (Pos. 12) is
active
Deactivate Emergency stop
(Pos. 12)
Fuel tank empty See Kubota operating manual!
Bleed the fuel line
See Kubota operating manual!
> Bleed the fuel system
Defective fuses Exchange the fuses (Pos. 14)
Low cutting performance
V-belt slips
Re-tensioning the V-belts
(see 6.9.2)
V-belt wear Change the v-belt
Low or unequal feed V-belt slips
Tension V-belt (see 7.9.2)
Change the v-belt
Lifting out does not function Defective fuse Exchange fuse (Pos. 14)
No cooling water on the saw
blade protective hood
Water filter dirty Clean water filter
Water hose kinked Check water hoses
Water pump fuse defective
Exchange water pump fuse
(Pos. 14)
Water pump defective Replace water pump
To Next Page
Loading...