17
4. Transport
4.1 Movement
Attention!
Floor cutter movement is only permitted with a stationary
saw blade.
For the MULTICUT 800, the saw blade must be removed!
For MULTICUT 800 G and MULTICUT 800 GH the drive lever
(Pos. 40) must be in the STOP position!
Attention!
Release the brakes (Pos. 22) and activate the feed (Pos. 23)
Switch on the ignition (Pos. 21) but do not start the diesel
motor
Slightly lift the floor cutter forwards using the toggle
switch (Pos. 19)
Start the diesel motor using the ignition (Pos. 21)
Introduce movement using the feed lever (Pos. 20)
4.2 Moving with the crane
Danger!
Personnel should never remain under hanging loads! Comply
with the load carrying capacity of the sling material!
Place the floor cutter onto the crane eye (Pos. 31)
Lift carefully and observe the weight distribution
Always keep an eye on the floor cutter
4.3 Set down manually
Danger!
Manual set down onto inclines or declines is forbidden!
Secure the floor cutter against roll away.
Release brakes (Pos. 22)
Release coupling (Pos. 23)
Move the feed lever (Pos. 20) forwards
Move the floor cutter slightly upwards with the toggle
lever (Pos. 19)
Push the floor cutter to the housing
To Next Page
Loading...