Lissmac MULTICUT 800 - Operation with Waste Water Suction

22
6. Operation with waste water suction
6.1 Operation of waste water suction (only MULTICUT 800 GH)
Exhaust can be turned on and off using the lever (Pos. 39)
Lever down = exhaust on
Lever high = exhaust off
6.2 Clean filter in dirty water container (Pos. 42) (several times daily)
Attention!
Switch off the motor of the floor cutter.
 Lift the exhaust using the lever (Pos. 43)
 Pivot out the collection container by the handle
 Remove the sieve from the container
 Clean and replace the sieve
(remember the latch)
 Return the collection container into position
 Lower using the lever (Pos. 43)
43
39
50