12
www.LiteGait.com
1-800-332-9255
LiteGait® Assembly
Tools Required:
Scissors
1/2 inch socket or open-end wrench
5/16 inch Allen wrench (provided)
LiteGait® WalkAble/ Jr. / MX Assembly Instructions:
Read below & follow pictures.
NOTE: Two people are required for safe assembly.
NOTE: Your LiteGait® may look different than the following
images, but assembly Steps are the same.
1.) Inspect shipment and note any visual
damage to box and/or crate
2.) Remove screw located at the bottom
of crate
3.) Lift off exterior box in order to ex-
pose equipment
4.) Examine contents. Report any
damage to equipment immediately to
Mobility Research Service & Parts
Department
6.) Remove cardboard harness and
accessories box.
7.) Open cardboard harness and
accessories box.
8.) Inspect contents of harness and
accessories box for damage.
9.) Carefully cut all black plastic straps
securing base to pallet.
5.) Loosen handle bar knobs and raise
handle bars.
10.) Using both people, remove base
from pallet.
NOTE: If you have any questions during installation, please
contact Mobility Research Service & Parts Department for
CAUTION: DO NOT USE UTILITY KNIFE
TO OPEN BOX
NOTE: Your LiteGait® may look different than images above
To Next Page
Loading...