LiteOn EVO600043S2D2E20F - Page 63

60
Parameter
Name
Description
Setting Range
Group o, Keypad Function Settings
o1: Display Setting
o1-00
Frequency
Command
Setting/Display Unit
0 : Use units of 0.01 Hz
1 : Use units of 0.01% (100% as maximum output
frequency)
2 : Use units of rpm
Default: 0
Range: 0 to 2
o1-01
<7>
V/f Frequency
ParameterUint
Setting
0 ：Hz
1 ：min -1(r/min)
Default: 0
Range: 0, 1
o1-02
User-Defined
Frequency
Command
Setting/Display
1 ~ 9999
Default: o1-00
Min.: 1
Max.: 9999
o1-03
Frequency
Command
Setting/Display
Decimal Places
0 ~ 3
Default:o1-00
Range: 0 to 3
o2: Multi-Function Selection
o2-01
STOP Key Function
Selection
Enables or disables the STOP key on the keypad
when the drive is controlled from a remote
source.
0 ∶ Disabled
1 ∶ Enabled
The STOP key always stops drive operation
even if the command source is not set to the
keypad.
Default: 1
Range: 0, 1
o2-03
Drive Capacity
Selection <2>
Set this parameter after replacing the terminal
block or drive modules.
Default: <2>
Determined by
drive capacity
o2-04
ENTER Key
Function During
Frequency
Command Setting
0 ∶ ENTER Key Required
1 ∶ ENTER Key Not Required
2 ∶ ENTER Key Not Required
Default: 0
Range: 0 ~ 2
o2-06
Operation
Direction at Power
Up when Using
Keypad
0 ∶ Forward
1 ∶ Reverse
This parameter is enabled only when the keypad
is selected as the Run command source.
Default: 0
Min.:0
Max.:1