Instruction manual
7
DESCRIPTION
1. Knob
2. Holding screw
3. Handle
4. Grill plate
5. Top grill plate
6. Connector
7. Holding screw
Before use:
- Assemble the parts using a hex wrench as shown below ( you can find the small screw in the small
tube part) .
- Before using for the first time, clean with a soft damp cloth, operate the appliance for 10 minutes
without any food to remove the residues of manufacturing. Well ventilated the room.
USING YOUR APPLIANCE
1. Put correctly the grill plate at the top of appliance
2. After fixed the cheese and adjusted the height thanks to the holding screw, then you can turn on
the switch to operate.
3.
You can move up and down the cheese rack to adjust melting temperature and you can control it
with the thermostat button.
You can put your food on the plate to roast or warm.
4. After grill enough, rotate the grill plate away from heater and lean the plate to get cheese with
spatula.
To Next Page
Loading...
