EasyManua.ls Logo

Lloyd LT48N - Cleaning and Maintenance Procedures; Indoor Unit and Filter Cleaning; General Maintenance Steps

Lloyd LT48N
25 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Maintenance
1. Select FANoperation mode,
make the air conditioner run a
long time to dry.
2. Turn off the air conditioner and cut off
the power supply.
4. Clean air filters and other parts.
3. Take out the batteries from the remote
controller.
For the purpose of safely, please turn off the air-conditioner and cut off the
power supply before cleaning.
Cleaning the indoor unit
Clean
WARNING:
1.Wipe the indoor unit with dry cloth .
2.If the indoor unit is very dirty, please wipe with wet cloth dipped by cold water.
3.The panel of indoor machine may be taken off. Dry it after cleaning with dry cloth.
NOTE :
Don't use dedusting products by chemicals or place close to the machine.
Don't use benzine, thinner or other similar solvent.
If the air filter is covered by dust, the cooling effect will be affected. Please regularly clean the
air filter.
1.Remove the screw on the top of the inlet panel. Grasp the inlet panel and gently pull forward
to yourself, then pull out the air filter.
2.Remove the dust on the filter by patting or with a vacuum cleaner. Please wash in warm
soapy water if too dirty, rinse and shake dry.
3. Dry the filter thoroughly then replace it.
Cleaning air filter
- 8 -

Related product manuals