★
1.Installation should always be carried out by specialist. The customers should not install
the air-conditioner by themselves. Otherwise, it may cause damage or injury.
2.In order to use the air conditioner properly, please refer to its working temperature range.
Otherwise, indoor unit automatic protection function may be activated, cooling or
heating efficiency will be weakened.
Safety tips
3.Set the suitable temperature, especially there are old people, children and patients in the
room. Generally, keep the temperature difference for 5℃ between the inside and outside.
4.In case that the unit occurs closing down due to the severe interference from outer
environments such as mobile phone, please cut off the plug and plug in to restart the
air conditioner after several seconds .
5.Never expose animals or plants to direct air flow, and adjust the air flow to avoid air
blowing directly at people.
6.It is forbidden to let the air conditioner blow wind to the cookers, or it may effect the
normal cooking and even cause danger!
The air-conditioner may can t run in normal followed under mentioned table
Cooling
Heating
Indoor
Outdoor
Indoor
Outdoor
＜18℃
＞43℃(A )pply to constant speed
＞30℃
＜-7℃(A )pply to constant speed
＞32℃
＞54℃(A T3)pply to
- 5 -
★
Auxiliary Electric Heater and other Instruction
1:Electric Heating Tube
2:One-time Fuse
3:Resettable Protector
2
3
1
1.The Fuse type and rated value to screen the corresponding controller or insurance on the
subject.
2.Auxiliary Electric Heater assembly in the leeward surface near the indoor evaporator ,
which belongs to the tubular metal electric heating element, The nameplate data power for
air conditioner are affixed shall prevail.
3.Auxiliary electric distance between heater and the shell keep 5cm, to prevent causing
combustion.
4.Auxiliary electric heater is installed on the left and right fixed seat, electric heating tube,
a one-time fuse and The Resettable protector if damaged, should ask professional personage
to replace, and the use of the company to provide components.
5.The interconnection of the connecting method of air conditioner and power line and each of
the independent components in air conditioner, posted on the circuit diagram shall prevail.
6.All indoor machine control panel with fuse.3.15A 250V (The fuse of floor standing model
with capacity for 12000W is 5A 250V)
Note: only instructions for auxiliary heating function apparatus。
To Next Page
Loading...