LM Technologies LM048 At Command Manual

AT Command Manual v1.5
©2013 LM Technologies Ltd www.lm-technologies.com Page 10 of 26
2.8.9.2 AT+ECHO?<cr>
2.8.9.2.1 Response
<cr,lf>ECHOc<command_response> if the command is successful. Here, c- current
echo back setting. E.g on default setup, the response will be
<cr,lf>ECHO+<command_response>
2.8.10 AT+RESP
The command is used to enable/disable the command response from the Bluetooth device. Different
types of command response may be received by Host device and are listed in
Command Response.
The current setting can also be retrieved by sending this command in query format.
2.8.10.1 AT+RESPc<cr>
Where parameter c is a character used to enable/disable the command response.
c
Command Response
‘+’
Enable
‘-‘
Disable
2.8.10.1.1 Response
<command_response>
2.8.10.2 AT+RESP?<cr>
2.8.10.2.1 Response
<cr,lf>RESPc<command_response> if the command is successful. Here, c- current
command response setting. E.g on default setup, the response will be
<cr,lf>RESP+<command_response>
2.8.11 AT+MODEM
This command is available only for v6.5x firmware running on serial adapters (LM048v2 and
LM058v2). This command is used in conjunction with AT+FLOW command to enable/disable various
RS232/Modem signal handling. The current setting can also be retrieved by sending this command in
query format.
2.8.11.1 AT+MODEMc<cr>
Where parameter c is used to disable or configure Local Loopback or Remote Transfer
settings on the adapter
C
Modem Signals
‘-’
Disable
‘L‘
Local Loopback
‘R’
Remote Transfer
2.8.11.1.1 Response
<command_response>
The meaning of the modems signals is described in section 2.8.11.3

LM Technologies LM048 Specifications

General

Brand	LM Technologies
Model	LM048
Category	Adapter
Language	English