To Next PageTo Next Page
Need help?Do you have a question about the Lochinvar Armor AWH0650N and is the answer not in the manual?
General| Model | AWH0650N |
|---|---|
| Category | Water Heater |
| Fuel Type | Natural Gas |
| Thermal Efficiency | 96% |
| Gas Connection Size | 1" NPT |
| Diameter | 24 inches |
| Weight | 150 lbs |
| Minimum Gas Supply Pressure | 5" WC |
| Maximum Gas Supply Pressure | 10 inches W.C. |
Specifies minimum distances from combustible materials and clearances for service access.
Defines closet/alcove criteria and specifies vent material requirements.
Details air supply requirements for different installation room types.
Warns against contaminants in combustion air and outlines necessary precautions.
Step-by-step guide for safely removing the water heater from its shipping pallet.
Instructions for converting the water heater from natural gas to LP gas.
Illustrates sidewall termination configurations for direct venting.
Illustrates vertical termination configurations for direct venting.
Guidelines for installing vent and combustion air piping, including material requirements.
Details on determining appropriate combustion air intake and vent piping sizes.
Guidelines for locating and installing sidewall vent and air terminations.
Instructions for cutting holes and preparing wall penetrations for vent and air piping.
Details on installing optional concentric vent termination kits for sidewall venting.
Guidelines for locating and installing vertical vent and air terminations on a roof.
Instructions for cutting roof penetrations for vent and air piping.
Details on installing optional concentric vent termination kits for vertical venting.
Requirements and considerations for outdoor installation configurations.
Specifies location criteria to prevent obstructions and ensure proper airflow.
Basic steps and considerations for installing system water piping.
Warnings and recommendations to prevent scalding from hot water.
Lists and describes essential piping components and their functions.
Step-by-step instructions for connecting the gas supply piping to the water heater.
Pipe sizing and pressure requirements for natural gas connections.
Pipe sizing and pressure requirements for propane gas connections.
Instructions for making 120 VAC power connections to the unit.
Instructions for routing and connecting low voltage wiring to the control board.
Procedures for wiring multiple water heaters in a cascade configuration.
Instructions for connecting and maintaining the condensate drain line.
Procedures for testing and adjusting water chemistry for optimal performance.
Safety procedures for checking gas connections for leaks before startup.
A checklist of final inspections and tests before initiating appliance startup.
Steps to verify burner ignition, flame pattern, and combustion analysis.
Details on built-in safety features like temperature and flue limiting.
Information on the appliance's freeze protection mechanism and installation precautions.
How multiple water heaters can be wired and controlled in a cascade sequence.
Describes the step-by-step sequence of events during appliance operation.
Tasks and procedures for annual startup and maintenance by a qualified technician.
Routine maintenance tasks recommended for the owner to perform regularly.
Procedures for annual cleaning of the condensate trap and system.
Steps to inspect all water and gas piping for leaks and ensure system integrity.
Electrical schematic illustrating the control logic and connections.
Detailed electrical wiring diagram of the appliance and its components.
