Loewe We. HEAR 1 - Advanced Features and Functions; Calls, AUX, and Battery; Charging and Water Protection

16 We. HEAR 1
english
5 Bluetooth phone call
When paired with the phone, if there
is an incoming call, music playback is
paused automacally. You can pick up
an incoming call by pressing
(Power)
buon once. To reject the call, press
(Power) twice quickly.
When an incoming call is answered, you
can use the built-in speaker microphone
for the call. It is located directly below
the
(Power) buon. When talking
to the microphone, make sure you are
close to it to ensure good sound clarity.
To end the call, press the
(Power)
buon once.
When you use two speakers on TWS
mode, please talk to the microphone on
the le channel speaker.
6 AUX connecon
Open the connector compartment of
the speaker and connect the speaker
with to your device with a 3,5 mm
audio cable. You can control the volume
by pressing the + / - buons. Shortly
press
(Power) buon to mute/
unmute the speaker.
7 Baery status
You can check the baery charge status
in the Bluetooth menu of your device.
During playback, the Bluetooth speaker
warns you by sound signal when the
baery level drops to low. The power
buon LED will also ash red.
Note: The baery charge level displayed
in the device Bluetooth menu is for
reference only. It may dier from the
actual baery level.
8 Recharging the baery
1. Open connector compartment of
the speaker.
2. Use a USB cable (included) and
connect it to the USB Type-C port on
the speaker.
3. Connect the other end of the cable
to a USB charger (not included). Use
a 5V/2A USB power supply to charge.
4. The red LED lights up while the
speaker is charging.
5. It may take up to 4 hours to fully
charge the baery.
6. Once it has nished charging, the
indicator light will go out.
9 IPX6 water protecon
This device has IPX6 protecon, which
means that strong water jets will not
have harmful eects on it.
For this protecon to be eecve, no
external devices may be connected to
the speaker via cables (such as phone
via audio cable or charger via USB
cable) and connector compartment
must be rmly sealed.