Sound & Electronics LOG GmbH | Sankt-Georgen-Gasse 7, 8020 Graz, Austria | ofce@logaudio.com | www.logaudio.com
2
IMAGE
User Manual
Integrate PROLOG into your home network
The easiest way to integrate the PROLOG into your home network is to use a Ethernet connection with your
network. Use the Ethernet connection on the back of the device. Your PROLOG will appear as a DLNA and
AirPlay® speaker in your network after a few seconds.
If you want to connect the PROLOG wirelessly to your own network, you can do this with the “AirLino®“-App:
1. Install the AirLino®-App which can be downloaded on the Apple App Store or Google Play Store
2. Activate WiFi on your device
3. Search for the WiFi-network “PROLOG“ and connect to it
Note: If your PROLOG is already integrated in your home network, you must connect to your home network.
4. Open the AirLino®-App. The setup wizard will start automatically
5. You can choose a custom name for your PROLOG to recognice the device easier in the future
6. Choose your home network name and enter the correct password of the network
The AirLino®-App will now try to connect your PROLOG to the home network
Note: If the device is not ready after 60 seconds there might occured an error. Please check if you entered the
correct network password and try the setup again. In some cases it is useful to unplug your PROLOG and try all
steps again after at least 10 seconds.
7. If the setup was successfully, your PROLOG is visible in the network. You can now see your PROLOG in your audio
streaming device.
8. Enjoy the music through your IMAGE
Note: Please make sure that the WiFi connection and the signal are stable and strong enough to manage high quality
audio signals in your home network. Low quality WiFi routers might cause problems. Please contact a wireless network
specialist if problems occur.
Streaming - wireless music playback with PROLOG 2
In combination with the PROLOG 2 you can stream music from a variety of sources wirelessly to the IMAGE wall speakers.
For this you need a wireless connection from your audio source (smartphone, tablet, etc.) to the PROLOG 2. The built-in
Bluetooth, AirPlay® and DLNA audio-receiving components start automatically and are ready after a short while. Then
connect to your smartphone, laptop, iPod touch, or similar device as follows:
Establish Bluetooth connection
1. Activate Bluetooth in the settings of your audio source (e.g. smartphone, tablet)
2. Search for “PROLOG“
3. Connect with “PROLOG“ like any other Bluetooth device
4. Make sure (in the settings of your audio source) that the audio signal is played via your Bluetooth connection
5. Enjoy the music through your IMAGE wall speakers
Note: When Bluetooth is activated once again, the device will automatically connect to the PROLOG 2 as soon as the
PROLOG 2 is within range.
Note: Not every device supports Blutooth apt-X. Therefore, the sound quality might differ.
To Next Page
Loading...