16
GB
Initial Setup
2. Connect the mains cable to the mains socket after
you have completed all the connections.
3. Switching on the POWER ON/OFF button which
is located at the rear side of the TV. At this stage,
the TV switches to standby mode. The red LED
indicator will illuminate on the front panel of the
TV.
4. In standby mode, press the
button on the right
side panel of the TV or on the remote control to
turn the TV on. The red LED indicator will turn
green.
Do not connect the TV to the mains
supply until you have completed all the
connections.
6. Press the buttons to navigate the menu and change the
settings. Press the OK button to confirm.
OSD Language Select your desired language to be displayed on
the menu. The default on-screen menu language
is set as English.
Country Select the country where you will operate the TV.
The default country is set as UK.
Dansk
Deutsch
Hrvatski
Italiano
OSD Language
OK
Magyar
Nederlands
Norsk
PolskiEnglish
Cesky
E k
Espanol
~
Fran ais
Portugues
Pycck
France
Greece
UK
Australia
Austria
Czech
Denmark
Finland
Country
OK
Belgium
Bulgaria
Croatia
Hungary
Italy
Luxembourg
Germany
Turning the TV on for the First Time
1. Connect one end of the RF coaxial cable to the
aerial socket on the wall and the other end of the
cable to the RF (75Ω) socket at the rear bottom
side of your TV.
5. The first time you turn the TV on, it will go straight into the First
Time Installation menu. Please ensure the aerial is plugged in
and then press the OK button. (If you have already installed the
TV using the Quick Start Guide, please go to the “Selecting the
Input Source” section on the next page.)
First Time Installation
Please ensure aerial is plugged in!
Then press OK button.
• Always disconnect the TV from the mains socket
when not in use for a long period of time.
• The
button on the right side panel of the TV or
on the remote control is only used for switching
the TV into standby, it does not disconnect the TV
from the mains power. To completely disconnect
the mains power, please remove the mains plug
from the mains socket.
Initial Setup
VGA INPUT
RF IN PUT
PC
AUDI O INPU T
SCA RT
HDMI 2
HDMI 1
OR
RF coaxial cable
(not included)
OFF ON
To the mains
socket
L26DIGB21_IB_111003_Annie.indd 16 11年10月3日 下午4:23
To Next Page
Loading...
General