HDMI2.0 4x1 Switcher
www.logicav.in 8
6. IR Remote Control
Please connect an IR receiver to the IR input port; the IR remote is used for signal
switching and it can also be used to control source and display devices based on CEC
function.
Note:
Due to the HDMI input 4 port does not support CEC, the source device connected to
this port can not be controlled by IR remote.
The source and display devices are required to support CEC when the IR remote is
used to control them.
INPUTS:
1~4: Select the corresponding input source.
MANUAL/AUTO: Switch Auto or manual mode.
SOURCE: Control the input source (e.g. DVD).
DISPLAY: Control the display (e.g. HDTV).
To Next Page
Loading...