LOGICDATA LOGIC OFFICE HSU Series User Manual

HSU - MANUAL // PAGE 15
7.1 ADJUSTING THE TABLE TOP HEIGHT
CAUTION Risk of minor or moderate injury through crushing
Your ngers may be crushed when you attempt to change the height of the table
• Keep ngers away from moving parts
• Ensure that no persons or objects are in the table's range of motion
INFO The Table Top will move up or down until the UP or DOWN Key is released, or if a pre-de-
ned stopping point has been reached.
To move the Table Top UP:
Press and hold the UP Key until the desired height has been reached
To move the Table Top DOWN:
Press and hold the DOWN Key until the desired height has been reached
7.2 SAVING A MEMORY POSITION
This function saves a set Table Top position. One Memory Position can be saved per Memory Position Key.
1. Move the table to the desired height
▸ The display shows the Table Top height (e.g. 73 cm)
SAVE
2. Press the SAVE Key.
2
3. Press the Memory Position Key (e.g. 2)
▸ The display shows S 2
7 3
▸ After about two seconds, the Table Top height is displayed again
7 3
s 2

LOGICDATA LOGIC OFFICE HSU Series Specifications

General

Brand	LOGICDATA
Model	LOGIC OFFICE HSU Series
Category	Controller
Language	English