LOGICDATA LOGIC OFFICE HSU Series User Manual

HSU - MANUAL // PAGE 16
7.3 ADJUSTING THE TABLE TO A MEMORY POSITION
Version A (without double-click function):
2
1. Press and hold the required Memory Position Key (e.g. 2).
▸ The Table Top will move until the saved Table Top height has been reached. If
you release the Key before the Memory Position is reached, the table will stop.
2
2. Release the Memory Position Key
7 3
7
▸ The display shows the Table Top height (e.g. 73 cm)
Version B (Auto-Movement with double-click function):
INFO The double-click function is available only for Table Systems sold in US markets.
INFO If you press any Key while the table moves to a Memory Position, the Table Top will stop
moving immediately. To continue, you must select the Memory Position again.
CAUTION Risk of minor or moderate injury through unauthorized modications
The rmware is delivered with a deactivated double-click function. If you activate this
function, the grading of the safety functions according to EN ISO 13849-1 PL b, Category
B, are no longer valid, as the legal requirements in the standard are no longer met.
• If you activate the function, perform a new risk new assessment to meet the higher
safety requirements (EN 60335-1). These cannot be met by LOGICDATA Control
Boxes.
• LOGICDATA is not liable for injuries or damage caused by activating the double-
click function
2
Double-click the required Memory Position Key (e.g. 2)
▸ The table will move to the Memory Position. You do not have to hold the Key
7 3
▸ The display shows the Table Top height (e.g. 73 cm)

LOGICDATA LOGIC OFFICE HSU Series Specifications

General

Brand	LOGICDATA
Model	LOGIC OFFICE HSU Series
Category	Controller
Language	English