13
Mute Function in Handset mode
1. During a call press the button. When the phone is holding, the
person at the other end of the call can hear music from the phone, but
cannot hear you. You can hear the music, as well, but can also hear the
caller if they speak.
2. To get back to the call, press the button again.
Mute Function in Speakerphone Mode
1. Press the button. The person at the other end of the call will
hear music but cannot hear you. You can hear the music as well, but
can also hear the caller if they speak.
2. To return to the call, press the button.
Use on PBX
If you are using your telephone on a PBX, and the PBX user guide tells you
to press the RECALL or FLASH button, press the button on the
base unit.
Inserting a Pause in the Dialing Sequence
1. For some switchboard systems, an access number must be dialled
(usually an 8 or 9) to get another dial tone and an outside line.
2. Press the button immediately after the access number to insert
a pause of about 3.6 seconds, and the desired number can be dialled
immediately.
3. Press the button to insert a pause when dialling or storing Long
Distance Access Codes.
Storing a Number in (0-9) two-touch memories
1. Lift the handset press the button.
2. Key in the telephone number you wish to store. Up to maximum 16
digits.
3. Press the button.
4. Press a 0-9 button to store the number in the selected memory.
5. Replace the handset on the base unit.
Do not press the HOLD button again or the call will end.
To Next Page
Loading...
General