GB-17
PreparationConnectionsInitial SetupUsing the FeaturesHints and Tips, Specification
and Safety Warnings
Using the Features
via USB port
6. Press the buttons to select your desired language to be displayed on the
menu and then press the OK button to confirm.
8. Select “Scan” on the screen and then press the OK button on the
remote control to start the First Channel Scan.
You can select the desired broadcasting signal region after scanning channels.
Select “Skip Scan” on the screen can cancel the Scan.
An initial Setup reminder will appear the next time you turn on
the TV.
Turning the TV On for the First Time
1. Connect the mains cable to the mains socket after you have
completed all the connections.
2. Switch on the POWER ON/OFF at the right side of the TV. At this
stage, the TV switches to standby mode. The red LED indicator
will illuminate on the front panel of the TV.
3. In standby mode, press the
/ button on the right side of the TV
or the
button on the remote control to turn the TV on. The red
LED indicator will turn blue.
Always disconnect the TV from the mains socket when not in
use for a long period of time.
The
/ button on the right side of the TV or the button
on the remote control is only used for switching the TV into
standby, it does not disconnect the TV from the mains power.
To completely disconnect the mains power, please remove
the mains plug from the mains socket or switch off the
POWER ON/OFF switch.
4. The first time you turn the TV on, it will go straight into the Initial
Setup menu. (If you have already installed the TV using the Quick
Start Guide, please go to the next step “Selecting the Input
Source” at the bottom of next page.)
5. Press the OK button to start the wizard.
VGA PC AUDIOCOAXIAL
S-VIDEO
SCART1
SCART2
HDMI2 HDMI1
To the mains socket
Please select your country:
Country
United Kingdom
Austria
Belgium
Croatia
Czech Republic
Denmark
Finland
aerial
7. Press the buttons to select the country where you will operate the TV
and then press the OK button to confirm.
9. After finishing the Scan, press the OK button to complete the
process. An opening screen will be displayed.
L32DIGB20_IB_final110325_running change_PN not updated.indd 17 25/03/2011 7:11 PM
To Next Page
Loading...
Need help?
General
