15
System Reset
There may be times when you need to reset your unit back to the factory settings,
especially if you have moved house or if you experience reception problems.
If you move to another part of the country and pick up the local and national DAB stations
in that area, your previously tuned channels may no longer be available.
1. Press the MENU button, then turn the VOLUME
SELECT control until “System” shows on the display.
2. Press the TUNE/ENTER button, then turn the
VOLUME SELECT control until “Factory Reset”
shows on the display.
3. Press the TUNE/ENTER button, then turn the
VOLUME SELECT control until “Factory Reset?”
shows on the display. Turn the VOLUME SELECT
control to choose Yes , then press the TUNE/ENTER
button to conrm. After the reset is complete, the
unit will go to standby mode.
4. Press the
STANDBY button again to turn the unit on, the unit will then start scanning
for DAB channels immediately.
• After the system reset, all the tuned stations, DAB and FM preset stations and
alarm settings will be erased.
• If you are using battery power and you reset your unit, once reset it will
automatically start to scan for DAB radio stations.
Display Backlight
In mains power mode there are four backlight levels to choose from.
To set the backlight level, repeatedly press the SNOOZE/DIMMER button and the
brightness of the display will change in sequence: High > Medium > Low > O
There are no backlight settings in battery mode.
L55DAB15_IB_Final200325V6.indd 15 25/03/2020 17:56
To Next Page
Loading...
Need help?
General
