16
DAB Operation
Ensure that you fully extend the aerial vertically before switching the unit on. When the unit
is connected to the mains power and then switched on from standby for the rst time, or
you have just performed a factory reset the unit will automatically enter into the DAB mode
and perform auto scan function.
During the scan the display will show “Scanning ...”
together with a slide bar that indicates the progress
of the scan and the amount of stations that have been
found so far.
Once the scan has nished, the unit will select the rst
alphanumerically found station.
To explore the found stations, press the TUNE/ENTER button and then turn the VOLUME/
SELECT control. When you nd a station that you would like to listen to, press the
TUNE/ENTER button.
If no stations are found after auto scan, the unit will then enter into the Tune
Select Menu. Turn the VOLUME/SELECT control and then press the TUNE/ENTER
button to select manual tune or full scan modes for stations.
DAB Auto Scan
The auto scan will search for the entire DAB Band III channels. After the scan has nished,
the rst alphanumerically found station will be automatically selected.
Full auto scan will not replace the DAB stations in memory. If you want to remove
all the previous scanned stations, system reset is required.
1. To activate auto scan, rst press the MENU button to enter into the Tune Select Menu,
then rotate the VOLUME/SELECT control to select “Full scan”, nally press the SELECT
button to conrm, the display will show “Scanning …” and a progressing slide bar.
2. All the stations that have been found will be stored automatically, to explore and
select listening to the found stations, press the TUNE/ENTER button and then turn the
VOLUME/SELECT control. Press the TUNE/ENTER button to conrm.
Secondary Services
You may see a “<” symbol after the name of the station, this indicates that there are
secondary services available to that station. These secondary services contain extra
services that are related to the primary station. e.g. a sports station may want to add extra
commentaries. The secondary services are inserted directly after the primary station in the
station list.
To select the secondary station, press the TUNE/ENTER button when the “<” appears
in the display before the station name. When the secondary service ends, the unit will
automatically switch back to the primary station.
L55DAB15_IB_Final200325V6.indd 16 25/03/2020 17:56
To Next Page
Loading...
Need help?
General
