EasyManuals Logo

Logik L612WD12 User Manual

Logik L612WD12
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #23 background imageLoading...
Page #23 background image
23
Theres a lot of foam • The amount of foam can vary depending on the temperature, level
and softness of your water.
• You may have used too much detergent.
• The type of detergent you use could cause excess foam.
Theres no foam • This can happen if you’ve put powder detergent directly into the
drum – you must put it in the detergent drawer.
• If your laundry has collected to one side of the drum, water will
be supplied automatically to correct the imbalance – and this will
prevent the foam wash.
• The amount of foam can vary, depending on the temperature, level
and softness of your water.
Fabric softener overflows • You may have exceeded the MAX level in the softener drawer.
• You may have spilt the liquid by closing the softener drawer too
sharply.
Theres a residue of powder
detergent at the end of the
wash
This can happen if you’ve put powder detergent directly into the drum –
you must put it in the detergent drawer.
Theres an unusual noise or
vibration
• Check theres nothing metal in the drum.
• Make sure the transit bolts used in transportation have been
removed.
• Check the washing machine is on a flat, stable surface.
Theres a noise when the
water drains away
This is normal, it’s the pump starting and stopping.
The electricity supply cuts
out while the washing
machines on
The washing machine will stop, and won’t start by itself when the power
comes back on. You’ll need to select a programme and start it again.
A circuit breaker trips the
electricity supply
• The washing machine will stop, and won’t start by itself when you
reset the breaker.
• You’ll need to find out what caused the breaker to trip, and put this
right. Then reset the breaker, turn your electricity supply back on,
and start the washing machine again.
The water supply is
disrupted
When the water comes back on, it may be impure at first.
You’ll need to disconnect the water-supply hose and drain any impure
water through the tap before using your washing machine again.
Remember to re-connect the water supply hose first.
L612S_WD12_IB_120627_RC_Pauline.indd 23 28/06/2012 10:00 AM

Other manuals for Logik L612WD12

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Logik L612WD12 and is the answer not in the manual?

Logik L612WD12 Specifications

General IconGeneral
BrandLogik
ModelL612WD12
CategoryWasher/Dryer
LanguageEnglish

Related product manuals