25
Display Fault What to do:
There is a lot of foam in
the washing machine or
motor failure.
Select and run a programme to fill and then drain the
washing machine or ask a qualified technician to repair
it.
Water overflow. Ask a qualified technician to repair it.
Drying temperature
sensor malfunction.
Ask a qualified technician to repair it.
Water level sensor
malfunction.
Ask a qualified technician to repair it.
Drying water level sensor
abnormity.
Check whether the clothes are dried or not, and whether
there is water in the washing machine. Dry it again after
the drying process.
Dryer error. Ask a qualified technician to repair it.
Washing machine has
an unbalanced load
protection function.
When unbalanced weight
is greater than allowable
maximum, the washing
machine will not spin and
will run at a low speed to
avoid abnormal vibration
and noise.
• In case washing 1 piece of laundry (carpet, bed sheet,
table sheet, etc) make it symmetrical inside the drum.
• Lower the wet weight of laundry pieces by wringing
manually and placing them back in the drum in
symmetrical position.
• Take out and then reposition the laundry pieces inside
the washing machine in a more balanced position on
the inner wall of the drum.
• Add 1 or 2 pieces of laundry into the drum to reduce
the unbalanced load effects.
• Restart the spin cycle by choosing Spin programme.
In case the failure persists, please ask a qualified
technician to repair it.
Communication
malfunction.
Ask a qualified technician to assist with repairs.
L612S_WD12_IB_120627_RC_Pauline.indd 25 28/06/2012 10:00 AM
To Next Page
Loading...
Need help?
General
